English
Justify the handle
Tools required:
Thermometer
3 mm Allen wrench
Turn the valve on. Place the thermometer in the
water stream.
Turn the temperature control knob until the output
water is 100°F.
Turn the water off.
Use a 3 mm Allen wrench to loosen the handle set
screw. Remove the handle from the valve (1).
2
Hold the handle lever in one hand. With the
other hand, turn the temperature control knob
approximately ½ turn clockwise (2a). Then,
without pressing inward on it, turn it counter-
clockwise until it is positioned vertically and hits
the safety stop (2b).
Install the handle (3). Tighten the screw.
a
b
10