Setting The Operating Mode/Calling Up The Settings Menu; Changing The Operating Status - Miele PAC 1045 Mode D'emploi

en - Operation

Setting the operating mode/calling up the Settings menu

You can change the set operating mode in any operating status by holding down the 
and  buttons at the same time for at least 3 seconds. You will then be prompted to enter
the following access code:
User code
3377
In order to change a digit in the access code, the cursor must be placed under the relev-
ant digit. The cursor position is changed by pressing and holding the  or  arrow but-
ton.
To increase the value of the digit (+1), briefly press the  button.

To decrease the value of the digit (-1), briefly press the  button.

To move the cursor one position to the right, press the  button for 3 seconds.

To move the cursor one position to the left, press the  button for 3 seconds.

When all of the code digits are set correctly, confirm the entry by pressing and holding

the  and  buttons at the same time for at least 3 seconds.
Settings
You are now in the
Select the required operating mode by holding down the  and  buttons at the same

time for at least 3 seconds.
Depending on which operating mode you select, further selectable options (e.g. Flow,

clock control, Room size) may be displayed. You can select these options or skip past
them by pressing the  and  buttons briefly at the same time.
The appliance switches back to the previous operating status with the newly selected op-
erating mode. If no actions are carried out in the
menu is exited automatically.

Changing the operating status

If you wish to change the operating status, you can switch between
Flow
(if selected via option),
Fan run-on at any time.
Press the  button repeatedly until you reach the desired operating status.

Tip: If you wish to clean the filter manually via Miele ThermoControl, press the  button re-
peatedly until you reach the
then be deactivated in the filter by Miele ThermoControl. After Miele ThermoControl, the
fan keeps running automatically in order to cool down the filter safely, after which the ap-
pliance switches back to the
46
menu.
Manual operation CO2 operation
/
ThermoControl active
Ready for operation
Settings
menu within 60 seconds, the
ThermoControl active
,
operating status. Relevant pathogens will
operating status.
Ready for operation ,
and