Operation; Initial Commissioning; Operating The Air Purifier - Miele PAC 1045 Mode D'emploi

Initial commissioning

Before carrying out initial commissioning, it is important to check that the air purifier is in-
stalled in accordance with appropriate use guidelines. After installation, allow the air puri-
fier to adjust to room temperature.
Check the air purifier, the plug and the mains connection cable for damage. If there is any
damage, the air purifier must not be used. Check the fuse rating of the socket before con-
necting the plug.

Operating the air purifier

The control panel for controlling the air purifier is located behind the lockable access flap
on the front of the plinth.
Check that the mains connection cable and the plug are intact.

Insert the plug into the socket.

Open the lockable access flap on the plinth of the air purifier and wait for the controls to

complete the self-test.
After the self-test, the
Mode
Use previous setting
Manual mode
Manual+time mode
Mode menu, the operating mode can be selected using the  and  buttons. You
In the
can use the previous setting (in the factory default settings, the previous setting is
mode
) or select a different operating mode. To confirm the selected operating mode, hold
down the  and  buttons for at least 3 seconds.
Depending on which operating mode you select, further selectable options (e.g. flow, clock
control, room size) may be displayed. You can select these options or skip past them by
pressing the  and  buttons briefly at the same time. The appliance will then switch to
Ready for operation
the
When the appliance is ready for operation, it can be switched on via the  button. If an
operating mode with clock (timer) is selected, the appliance will switch on automatically at
the set time.
If you do not select a menu option within 60 seconds, the previous setting will be adopted
automatically and the appliance will switch to the
After this step, the operating mode can only be changed in the
Further selectable options relating to the operating modes may be available in the
tings menu.
Tip: The previous setting can be selected more quickly in the
ing the  button or by pressing the  and  buttons briefly at the same time.
Mode
menu appears.
operating status.
Ready for operation
Settings
Mode
menu by simply press-
en - Operation
Manual
operating status.
menu.
Set-
43