Technical Specification - Velleman SOL20 Notice D'emploi

Charging
4.
Refer to the illustrations on page 2 of this manual.
The solar charger must be charged prior to use. Do not press the
ON/OFF button [E] before or during charging as this will start
discharging the internal battery!
• Adaptor or USB port: Connect the mini USB input [D] to an adaptor
with output range 4.5~6.0Vdc (not incl.) or to a powered USB port
using the included cable (charging time ±1.5h).
• Solar charging: Place the solar charger with the solar panel facing
the sun into bright sunlight. Charging time ±15~20h.
• During charging the charging LEDs [C] light up – the number of LEDs
indicate the charging level (4 red LEDS mean the SOL20 is fully
charged.
Use
5.
• Connect the included cable to the USB port [F].
• Connect the desired plug to the end of the cable and connect your
appliance.
• Press the ON/OFF button [E] to start charging the connected device.
The green discharging LED [A] lights up.
Note: the blue solar LED [B] lights up as soon as the solar panel
receives enough sunlight to charge the internal battery.
• A single flashing charging LED [C] indicates the battery of the SOL20
is almost depleted. Disconnect the appliance and recharge the
SOL20 (refer to §4).
Battery
6.
• This charger contains an internal rechargeable battery. When the
device is end‐of‐life, this battery has to be removed.
WARNING: Never dispose of batteries in fire, as they could explode.
Keep batteries away from children.
Technical Specification
7.
solar panel
battery
output voltage
output current
input voltage
max. input current
charging
full sunlight
times
USB
discharging time
18.10.2011
SOL20
monocrystalline silicon 5.5V‐0.3W
high‐capacity built‐in polymer, 1200mAh
5.0Vdc±0.1Vdc
max 750mA
4.5‐6.0Vdc
1A
15~20h
1.5h
75‐100min
5 ©Velleman nv