Dimplex DGWH4031 Manuel Du Propriétaire page 8

Heater Installation
INSTALLATION WITH WALL/
CEILING HANGER BRACKET
!
NOTE:
To prevent personal
injury always use a licensed
electrician to install new outlets or
circuits.
Use of the hanger bracket allows
the unit to be rotated approx 45°
in each direction from centre, and
tilted in a range of 45° while sus-
pended from a wall or ceiling.
!
NOTE: The hardware for
mounting the hanger bracket to
the wall or ceiling is not included.
CAUTION:
and/or tilting the heater do not
block the exhaust opening.
The following steps are shown in
Figure 3.
1. Locate a stud or other suit-
able support and install hanger
bracket on wall or ceiling.
Select a location where the
control knob can be easily
reached.
2. Insert carriage bolt into square
opening of heater handle.
3. Slide spacer over the carriage
bolt shaft and insert in hanger
bracket opening and hold them
in position.
4. Slide lock washer and thread
on T-Handle onto carriage bolt,
turning to tighten.
8
When turning
Figure 3
Hanger
Bracket
Spacer
Carriage
Bolt
Air In
Wiring
T-Handle
Lock Washer
Air Out
www.dimplex.com