Technical Specifications - tomado TDH8001W Mode D'emploi

Problem
Display is not on
"FUL" lights up
" " lights up
Dryer does not start
Degree of dryness was not reached
or drying time too long
There are humming noises
The dryer switches off at the end
of the programme
WARNING!
If you cannot resolve the problems yourself and need help:
• Press the ON/OFF button.
• Pull out the mains plug and call the customer service.

TECHNICAL SPECIFICATIONS

Model
Dimension(L*W*H)
Ambient temperature
Rated input power
Rated voltage
Rated frequency
Refrigerant
Weight of product
Rated capacity
i
NOTE!
• The rated capacity is the maximum capacity, make sure that the dry clothes loaded into the appliance do not exceed
the rated capacity.
• Do not install the tumble dryer in a room with a risk of frost. At temperatures around freezing point, the tumble dryer
may not be able to operate properly.
• There is a risk of damage if the condensate water is allowed to freeze in the pump, hoses and / or condensate tank.
Solution
• Check if the power supply works.
• Check if the mains plug is inserted.
• Check the selected programme.
• Press the ON/OFF button.
• Empty the condensate tank.
• If the light still remains on, please call the service centre.
• Clean the dryer filter.
• Connect the tumble dryer to the mains.
• Turn on the tumble dryer.
• Check if the door is closed.
• Check if the programme is set.
• Press the START/PAUSE button.
• Clean dryer filter and condenser unit.
• Empty the condensate tank.
• Check the drain hose.
• Check if installation place is appropriate.
• Keep the air inlet clean.
• Use higher drying intensity level programme or
• time programme.
• The compressor is operating. These noises are quite normal and do not indicate
a fault.
• The dryer switches off automatically in order to save energy. This is not an error
but a normal function.
TDH8001W
650x595x845 mm
+5 °C ~ +35 °C
800 W
220-240 V~
50 Hz
R290
49 kg
8,0 kg
EN - 38