tomado TDH8001W Mode D'emploi page 36

WARNING! Always unplug the appliance before cleaning and maintenance.
CLEANING THE EXTERIOR OF THE APPLIANCE
Proper maintenance on the appliance can extend its useful life. Clean the exterior of the appliance and
control panel using a soft damp cloth and water. If necessary, a diluted non-abrasive neutral cleaning
agent can be used to clean the appliance.
EMPTYING THE CONDENSATE TANK
1. Pull out and hold the condensate tank with two hands.
2. Tilt the condensate tank, pour out the condensate water into the basin.
3. Install the condensate tank.
WARNING!
• Empty the condensate tank after each use. Should the condensate tank fill up completely, the programme will be paused and
the symbol " " will light up. Once the tank is emptied, the dryer can be restarted by pressing the START/PAUSE button.
• Do not drink the condensate water.
• Do not use the dryer without the condensate tank.
CLEANING THE DRYER FILTER
1. Open the door.
2. Take out the filter.
3. Open the filter and remove the fluff on the filter. You can clean it in water.
4. Dry the filter thoroughly before installing it again, or let it air dry for a few hours
before installing it again.
i
NOTE!
• The lint accumulated on the dryer filter will block the air circulation, which will result in a longer drying
time and an increased energy consumption. Therefore, the dryer filter must be cleaned after each use.
• Take notice of the correct orientation before inserting the dryer filter.
• Do not operate the dryer without the dryer filter!
• Clean the dryer filter after each use to prevent lint accumulation inside the dryer.
MAINTENANCE
EN - 36