Installation And Connection; Unpacking The Appliance - tomado TDH8001W Mode D'emploi

REQUIRED SPACE FOR INSTALLING
WARNING!
• Stability is important to prevent the product from moving across the installation site! Make sure
to level the appliance and install it on a stable base in longitudinal and traverse direction by screwing
the adjustable feet up or down.
• Make sure the appliance is not standing on the power cord.
• Make sure to observe the minimum required clearances from the walls as indicated in the figure.
• Do not place the appliance on a carpet with long fibres, as this may impede air circulation.
i
The room in which the appliance is placed must meet the following requirements:
1. Dry, level and stable solid base
2. Avoid direct sunlight
3. A clean location, where dirt does not accumulate. Air must be able to circulate freely around the
appliance. Do not obstruct the front air inlet or the air intake grills at the back of the machine.
4. Room temperature is between 10°C and 25°C
5. Place the appliance in a well-ventilated room, as the use of this appliance may generate heat and
humidity. Keep far away from heat sources such as coal, gas or wood burning appliances
6. Do not stack this dryer on a washing machine without a stacking kit.
7. Never tilt the dryer more than 30° if the dryer can't be transported right side up.

UNPACKING THE APPLIANCE

WARNING!
• Move the appliance with at least two people and wear protective clothing, such as sturdy gloves.
• Packaging material (e.g. films, styrofoam) can be dangerous for children.
• There is a risk of suffocation! Keep all packaging away from children.
INSTALLING THE EXTERNAL DRAINAGE HOSE (INCLUDED)
• Install the external drainage hose if you do not want to use the internal condensate tank.
Pull up the upper drain hose

INSTALLATION AND CONNECTION

Connect the external drain
hose to the water pump
EN - 29
Put the external drain
hose into the floor drain
(be careful not to bend
the external drain hose)
W ≥ 10 cm