Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 13 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end w ill fi t 5/8", 3/4" or 1"
diameter connections on the air gap, w aste tee or
disposer. Cut on the marked line as required for your
installation.
Cutting Lines
1"
3/ 4"
IM PORTANT: Do not cut corrugated
portion of hose
Figure W
• If a longer drain hose is required, add up to 42" of
length for a total of 10 ft. to the factory installed hose.
Use 5/8" or 7/8" inside diameter hose and a coupler to
connect the tw o hose ends. Secure the connection
w ith hose clamps.
Hose Clamp
• Secure the drain hose to the air gap, w aste tee or
disposer w ith clamps.
NOTE: TOTAL DRAIN HOSE LENGTH M UST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
Installation Instructions
5/ 8"
Hose Clamp
Coupler
Figure X
DRAIN LINE INSTALLATION
• Connect drain line to air gap, w aste tee or disposer
using either previously determined method.
Method 1 – Air gap with waste tee or disposer
Waste Tee Installation
Method 2 – High drain loop with waste tee or disposer
Fasten to underside
of countertop
32"
Min.
18"
M in.
Waste Tee Installation
IMPORTANT
–
W hen connecting drain line to dis-
poser, check to be sure that drain plug
has been removed. DISHWASHER W ILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Alw ays
be sure disposer drain plug has been removed before
attaching dishw asher drain hose to the disposer.
10
Disposer Installation
Fasten to underside
of countertop
18"
M in.
Disposer Installation
Remove
Hopper
Plug
Publicité
Table des Matières
