Teac SR-L250i Manuel Du Propriétaire page 6

Discs that can be played on this unit:
• Commercial audio CD's bearing the "Compact
Disc Digital Audio" logo:
• Properly finalized CD-R/CD-RW discs.
Note:
< Depending on the quality of the disc and/or the
condition of the recording, some CD-R discs may
not be playable.
< Copy-protected discs and other discs which do not
conform to the CD standard may not play back
correctly in this player.
If you use such discs in this unit, TEAC Corporation
and its subsidiaries cannot be responsible for any
consequences or guarantee the quality of
reproduction. If you experience problems with such
non-standard discs, you should contact the
producers of the disc.
< Always load the disc with the label side up.
(Compact discs can be played or recorded only on
one side.)
< To remove a disc from its storage case, press down
on the center of the case and lift the disc out,
holding it carefully by the edges.
How to remove the disc
< Should the disc become dirty, wipe the surface
radially with a soft, dry cloth. Never clean the disc
using a circular motion.
6
Discs
How to hold the disc
< Never use such chemicals as record sprays,
antistatic sprays or fluid, benzene or thinner to
clean the discs. Such chemicals will do irreparable
damage to the disc's plastic surface.
< Discs should be returned to their cases after use to
avoid dust and scratches that could cause the laser
pickup to "skip".
< Do not expose discs to direct sunlight or high
humidity and temperature for extended periods.
Long exposure to high temperatures will warp the
disc.
< CD-R/CD-RW discs are more sensitive to the effects
of heat and ultraviolet rays than ordinary CDs. It is
important that they are not stored in a location
where direct sunlight will fall on them and which is
away from sources of heat such as radiators or
heat-generating electrical devices.
< Printable CD-R/CD-RW discs aren't recommended,
as the label side might be sticky and damage the
unit.
< Do not stick papers or protective sheets on the
discs and do not use any protective coating spray.
< Use a soft oil-based felt-tipped pen to write the
information on the label side. Never use a ball-point
or hard-tipped pen, as this may cause damage to
the recorded side.
< Never use a stabilizer. Using commercially available
CD stabilizers with this unit will damage the
mechanisms and cause them to malfunction.
< Do not use irregular shape CDs (octagonal, heart-
shape, etc.). CDs of this sort can damage the unit.
< If you are in any doubt as to the care and handling
of a CD-R/CD-RW disc, read the precautions
supplied with the disc, or contact the disc
manufacturer directly.