Murray 612100 4NA Serie Manuel De L'utilisateur page 4

Your snow shovel was completely assembled at the factory,
except for the upper handle assembly.
Shipping Carton
Carefully remove complete unit from carton. Make sure parts bag
and all components have been removed before discarding
carton.
The shipping carton contains the following items:
S Snow shovel housing, with lower handles attached.
S Upper handle loosely attached to lower handle by the wire
harness.
S Plastic bag, containing the following parts (Figure 1):
S Owner's Manual
S Plastic probe
S Set center grip (left & right pieces)
S Strain Relief
S (4) #8 X 3/4 screws
Assembly
1. Remove and discard wire protector from lower handle tube.
Figure 2.
NOTE: Care should be given as not to damage wire harness
while assembling snow shovel.
2. Slide the upper handle assembly into the lower handle.
NOTE: You may find it difficult to slide the upper handle
assembly into the lower handle during initial assembly. This
is due to the close tolerance fit between the upper and lower
tubes, required to ensure a rigid assembly. If this problem
arises proceed as follows:
S Place a small amount of grease or oil on the inside of lower
tubes. This will ensure a smooth and even fit when sliding
upper tubes into lower tubes.
S Fold wire harness, and insert excess wire into lower right
handle tube. Put as much of the wire harness as possible into
lower tube.
S While holding lower grip firmly, carefully slide the right and left
upper handle tubes into lower handle tubes until two holes are
aligned evenly on both sides. DO NOT DAMAGE WIRE
HARNESS. Figure 2.
S Wipe off any excess grease or oil.
3. Position left center grip, point arrow (found inside of grip)
down, towards the shovel housing, onto handle so that the
tabs in the grip align with the holes on handle tubes. Figure 3.
F-041073C
All manuals and user guides at all-guides.com
ASSEMBLY
4
Center Grip
Strain Relief
Center Grip
* Arrow Down
4. Press left grip firmly against handle tubes, it will snap into
position. Figure 3.
Screws
Plastic Probe
Figure 1
Upper Handle
Tube
Lower Handle
Tube
Figure 2
Handle Tube
Figure 3