R&G FI0103BK Instructions De Montage page 8

Left-hand side (Lower)

Fit the counter sunk headed bolt through frame insert so head sits in counter-sink.

Place special nut on exposed end of bolt so tapered face goes into tapered recess.

Tighten bolt until tapered portion of nut just contacts tapered face of plastic frame insert.

Place the assembly into the frame recess.

Tighten bolt so frame insert is held in position firmly (do not over tighten).

Place bubble sticker as shown above.

Regularly check to ensure frame insert remains tight.
INSTRUCTIONS DE MONTAGE FI0106BK INSERT CADRE
KAWASAKI NINJA H2 2015- COTE GAUCHE & DROIT INFERIEUR
L
E KIT CONTIENT LES ARTICLES EXPOSES CI
L
A FAÇON DONT LE KIT EST EMBALLE NE CORRESPOND PAS FORCEMENT A LA FAÇON DE MONTER LES PIECES SUR LA
LES PARTIES PRESENTEES PEUVENT ETRE UNIQUEMENT REPRESENTATIVES (POUR LA CLARTE DES
Unit 1, Shelleys Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0) 1420 89007 | Fax : +44 (0) 1420 87301 | Email: info@rg-racing.com
TOOLS REQUIRED

3mm metric Allen key.
ISSUE 1 NSY 13/05/2015
- ,
DESSOUS VERIFIER QUE TOUTES LES PIECES SOIENT PRESENTES AVANT DE
PROCEDER AU MONTAGE
.
MOTO
INSTRUCTIONS UNIQUEMENT).
R&G Racing
.