R&G FI0103BK Instructions De Montage page 15

Notez que si les kits sont emballés avec des rondelles en caoutchouc servant à tenir les composants,
Coté droit (avant)

Passer le boulon à travers l'insert de cadre de façon à ce que la tête se place dans le contre alésage.

Placer l'écrou spécial sur l'extrémité exposée du boulon pour que la face conique aille dans le creux
conique.

Serrer le boulon jusqu'à ce que la portion conique de l'écrou vienne toucher la partie conique de
l'insert cadre en plastique.

Placer l'ensemble dans le creux du cadre.

Serrer le boulon pour que l'insert de cadre soit tenu correctement en position (Ne pas bloquer).

Placer le sticker caoutchouc comme ci dessus.

Vérifier régulièrement le serrage de l'insert de cadre.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes
which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer
acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those in R&G's
order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its particular
purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify any fault free of
charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not
affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a replacement or refund the
purchase money but shall not be liable if the Products have been modified or used or maintained otherwise than in accordance with R&G's
or manufacturer's instructions and good engineering practice or if the defect arises from accident or neglect. Other than identified above and
subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or consequential loss and
otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do
not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were
purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable
condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at
the prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns of discontinued products, unless
within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty goods.
Unit 1, Shelleys Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0) 1420 89007 | Fax : +44 (0) 1420 87301 | Email: info@rg-racing.com
ces rondelles doivent être jetées.
Outils requis

Clé Allen 3mm.
ISSUE 1 NSY 13/05/2015
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing