Tool Specifications; Operating Pressure; Fastener Specifications - Stanley Bostitch SF150 Manuel D'instructions Et D'entretien

All dimensions in inches unless otherwise specified.
Description
Operation Pressure Range
Maximum Operation Pressure
Fastener Type
Fastener Diameter
Fastener Range
Magazine Capacity
Length
Width
Height
Weight
Steel Gauge Range
Tool use with steel gauges thicker than 16 gauge or thinner than 20 gauge is not recommended.

OPERATING PRESSURE:

70 to 120 psig (4.9 - 8.4 kg/cm
DO NOT EXCEED THE RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The SF150C requires 5.58 cubic feet per minute (.16 cubic meters) of free air to operate at the rate of 100
nails per minute, at 80 psig (5.6 kg/cm
amount of air required. For instance, if your fastener usage averages 50 nails per minute, you need 50% of
the tool's cfm which is required to operate the tool at 100 nails per minute.
Tool Model Steel Gauge
54 - 33 mil
SF150C 16 - 20 gauge
(1.37 - 0.84 mm)
Visit www.BOSTITCH.com for further details.
NOTE:
STANLEY-BOSTITCH tools have been engineered to provide superior customer satisfaction and are
designed to achieve maximum perfomance when used with precision STANLEY-BOSTITCH fasteners
engineered to the same exacting standards. STANLEY-BOSTITCH cannot assume responsibility for product
performance if our tools are used with fasteners or accessories not meeting the specific requirements
established for genuine STANLEY-BOSTITCH fasteners and accessories.
SF150C
Light Gauge Steel Coil Nailer
70 - 120 psig (4.9 - 8.4 kg / cm
120 psig (8.4 kg / cm
15° Wire Collated Coil
.100" (2.54 mm)
1" - 1-1/2" (25 - 38 mm)
200
12.15" (309 mm)
5" (127 mm)
10.64" (271 mm)
5.88 lb (2.66 kg)
16 - 20 gauge, 54 - 33 mil (1.5 - 0.8 mm)
2
). Select the operating pressure in this range for best fastener performance.
2
). Take the actual rate at which the tool will be run to determine the
Primary Applications
Wood to Steel
Steel to Steel
Plywood to Steel
OSB to Steel
Plywood to Steel
OSB to Steel
Gypsum to Steel
Cement Board to Steel

TOOL SPECIFICATIONS

2
)
2
)

FASTENER SPECIFICATIONS

Fastener SKU Shank Diameter
C2S100BG
C4S100BG
GC4S100BG
- 5 -
Length
.100 (2.54 mm) 1" (25 mm)
.100 (2.54 mm) 1-1/2" (38 mm)
.100 (2.54 mm) 1-1/2" (38 mm)