Before Use; Mounting The Agitator; Dismantling The Agitator; Installing The Support Bracket - Parkside PFMR 1400 C2 Instructions D'utilisation Et Consignes De Sécurité

Before use

Always pull the mains plug before executing
settings on the device.
Mounting the agitator (see Ill. A)
Firmly screw the shaft
7 b
Subsequently, screw the agitator
agitator shaft with the M-14 inner threading
Secure the chuck with an open-end spanner
and tighten the stirrer
end spanner .
2

Dismantling the agitator

To remove the agitator, repeat the process in
the reverse order.

Installing the support bracket

Install the support bracket
four included crosshead screws in the desig-
nated location on the handle (see Fig. C).

Using the support bracket

Use the support bracket
or to set it on the ground. This will prevent it
from dirtying.

Operation

Turning the device ON / OFF

(see Ill. B)
Switching on:
Press the ON / OFF switch
Switching off:
Release the ON / OFF switch
All manuals and user guides at all-guides.com
Before use / Operation / Maintenance and Cleaning
to the mixing spiral .
7 a
into the
7
.
4
2
with a second open-
7
by securing the
3
to hang the device
3
.
5
.
5
Switching on permanent operation:
Secure ON / OFF switch
button .
6
Switching off permanent operation:
Press ON / OFF switch
Setting the speed (see Ill. B)
Note: The ON / OFF switch
speed control.
Note: The speed cannot be adjusted in non-stop
operation.
Press the ON / OFF switch
the speed.
Increase the pressure to increase the speed.

Working with the mixer

Submerge the mixer in the mixture at a low
speed.
After the agitator has been submerged com-
pletely, you may increase the speed.
During the mixing process, move the agitator
around the mixing vessel and mix the mixture
until it is completely processed.

Maintenance and Cleaning

DANGER OF INJURY! Pull
the mains plug out of the mains socket before you
carry out any task on the device.

Cleaning

Use a dry cloth to clean the casing. Under no
circumstances should you use petrol, solvents
or cleaning agents, which may be aggressive
to the plastic.
Always keep the device clean, dry and free of
oil or grease. Do not allow liquids to enter the
interior of the paint and mortar mixer.
Clean the paint and mortar mixer regularly,
preferably immediately after finishing your work.
with hold-to-run
5
quickly.
5
has a variable
5
lighlty to reduce
5
GB/IE 9