Samsung HT-D6759W Manuel D'utilisation page 20

Connections
!
CAUTION

Do not let children play with or near the speakers. They could get hurt if a speaker falls.

When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.

Keep the subwoofer speaker out of reach of children so as to prevent children from inserting their
hands or alien substances into the duct (hole) of the subwoofer speaker.

Do not hang the subwoofer on the wall through the duct (hole).

Do not insert any other card except the TX card dedicated to the product.
If a different TX card is used, the product may be damaged or the card may not be removed
easily.

Do not insert the TX card upside down or in the reverse direction.

Insert the TX card when the product is turned off. Inserting the card when it is turned on may
cause a problem.

The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.

For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.

If no sound is heard from the wireless surround speakers, switch the mode to Dolby Pro
Logic II.

In 2-CH mode, no sound will be heard from the wireless surround speakers.
✎
NOTE

If you place a speaker near your TV set, screen colour may be distorted because of the magnetic fi eld.

Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is
too close to the product, some sound interruption may be heard due to interference.

If you use a device such as a microwave oven, wireless LAN Card or any other device that uses
the same frequency (2.4/5.8GHz) near the product, some sound interruption may be heard due
to interference.

The transmission distance from the product to the wireless receiver module is about 10m, but may
vary depending on your operating environment. If a steel-concrete wall or metallic wall is between
the product and the wireless receiver module, the system may not operate at all, because the radio
wave cannot penetrate metal.

If the product doesn't make wireless connection, the system needs ID Setting between the
product and wireless receiver module. With the main unit turned off, press the remote control's
"0""1""3""5" number buttons and then turn on the unit. With the wireless receiver module
turned on, press "ID SET" button on the back of the wireless receiver module for 5 seconds.
And then power on the product (HT-D6750W).
Attaching the Toroidal Ferrite Core to the Power Cord of the Main Unit
If you attach a Toroidal ferrite core to the power cord of the man unit, it will help to prevent RF
interference from radio signals.
1. Pull the fi xing tab of the Toroidal ferrite core to
open it.
2. Make a loop twice in the main unit power cord.
3. Attach the Toroidal ferrite core to the main unit power
cord as the fi gure shows and press it until it clicks.
20
English
HT-D6759W_ZG_0323.indd 20 HT-D6759W_ZG_0323.indd 20
FM ANT COMPONENT OUT SPEAKERS OUT
CENTER FRONT
HDMI IN
SUBWOOFER FRONT
WIRELESS
AUX IN VIDEO OUT SPEAKER IMPEDANCE : 3
FRONT TOP
FRONT TOP
2011-03-23 2011-03-23 10:02:57 10:02:57