Speaker Components; Installing The Speakers On The Tallboy Stand - Samsung HT-D6759W Manuel D'utilisation

Connections

Speaker Components

(L) (R)
FRONT/FRONT TOP
SCREW (4x20): 16EA
SCREW (5x15): 8EA

Installing the Speakers on the Tallboy Stand

1. Turn the Stand Base upside-down and connect
it to the Stand.
2. Insert small screws (4x20, For connecting Stand
& Stand Base) clockwise into the four holes
marked using a screwdriver as shown in the
illustration.
!
CAUTION

When you use a torque screwdriver, be careful
not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver-
below 15 kg.f.cm)
3. Insert the large screw (5x15, For connecting
Stand & Stand Base) clockwise into the hole on
the rear of the stand using a screwdriver.
4. Connect the upper Speaker to the assembled
Stand.
5. Insert another large screw (5x15, For connecting
Speaker & Stand) clockwise into the hole on the
rear of the speaker using a screwdriver.
6. This is the appearance after the speaker is
installed.
Follow this steps to install other speaker.
18
English
HT-D6759W_ZG_0323.indd 18 HT-D6759W_ZG_0323.indd 18
STAND SUBWOOFER
CENTRE
(L) (R)
SURROUND
SWA-5000
Wireless Receiver Module
SPEAKER CABLE
STAND BASE
1
Stand Base
Stand
3
5
TX Card
Speaker Cable (2EA)
2
4
Speaker
Stand
6
or
2011-03-23 2011-03-23 10:02:44 10:02:44