Air Supply And Connections; Loading Tool - Ryobi YG100P Manuel D'utilisation

AIR SUPPLY AND CONNECTIONS

 Do not use oxygen, combustible gases or bottled gases
as a power source for this tool as tool will explode,
possibly causing injury or death.
 Do not use with an air compressor which can potentially
exceed 200 psi, as tool may burst, possibly causing
injury.
 The connector on the tool must not hold pressure when
air supply is disconnected. If an incorrect fitting is used,
the tool can remain charged with air after disconnecting
and thus will be able to drive a fastener even after the air
line is disconnected, possibly causing injury.
 Always disconnect air supply:
• Before making adjustments
• When servicing the tool
• When clearing a jam
• When tool is not in use
• When moving to a different work area, as accidental
actuation may occur, possibly causing injury.
All manuals and user guides at all-guides.com
SPECIFIC SAFETY RULES
4 — English

LOADING TOOL

 Do not load the tool with fasteners when any one of
the operating controls is activated.
When loading tool:
 Never place a hand or any part of body in fastener
discharge area of tool.
 Never point tool at anyone.
 Do not pull the trigger, as accidental actuation will
occur, possibly causing injury.
SAVE THESE INSTRUCTIONS
 Refer to them frequently and use them to instruct others
who may use this tool. If you loan someone this tool, loan
them these instructions also.