Tips & Troubleshooting - Gallagher B60 Notice D'utilisation

TIPS & TROUBLESHOOTING
Turn off energizer before handling fence or ba ery connec ons.
Symptom
Status LED is
solid red
No voltage on
fence
Note: Approvals & Standards - FCC
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protec on against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruc on manual, may cause harmful interference to radio communica ons.
Opera on of this equipment in a residen al area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.
10
3E4721 Gallagher B60 Portable Energizer User Manual
Problem
Energizer has stopped pulsing due
to ba ery voltage falling less than
11 V. (This protects the ba ery
from permanent damage.)
• Fence shorted
• Fence disconnected from
energizer.
• Energizer may have been
damaged by lightning
Solu on
Replace fl at ba ery with a
fully charged one
Check energizer isn't
faulty;
- disconnect from fence
and earth
- measure across fence
and earth terminals
with a Gallagher Fence
Volt Meter
- if less than 5 kV return
energizer for service
- if more than 5 kV the
fault is with the fence
or earth system.