Electrical Wiring - Riello Burners 40 G5 Manuel D'entretien

ELECTRICAL WIRING

230V
N
N
1 2 3
Parts Available from
Valve
www.sparesgiant.com
D5228
NOTES
2
– Wires of 1 mm section.
– The electrical wiring carried out by the installer
must be in compliance with the rules in force in
the Country.
– To remove the control-box from the burner,
loosen screw (A) (see figure) and pull towards
the arrow.
– The photoresistance is fitted directly into the con-
trol-box (underneath the ignition-transformer) on
a plug-in support.
TESTING
Check the shut-down of the burner by opening the
thermostats.
ATTENTION
Do not connect burner's grounding, to failure
indicator terminal . This may result the destroy
of the control box.
2346
All manuals and user guides at all-guides.com
~
50Hz
L
Switch with fuse
6A max.
L
4 5 6 7
M
Black
~
Capacitor
Motor
WARNING
Do not exchange the neutral with the phase.
T
T
Remote lock-out lamp
(230V - 0.5A max.), if required
Terminal block of
8 9
control-box 530SE
A 3
RUN OF THE ELECTRICAL CABLE
1 - Grommet
2 - Cable-clamp
3 - Terminal block
5 GB
Regulating thermostat
Limit thermostat
with manual resetting
*
S7026
2 1
N - Neutral
L - Phase
- Burner-earth