Johnson Pump SPX FLOW ULTIMA BILGE 600 GPH Manuel D'instructions page 9

PUMP
***Make sure to have at least 1 inch
[25MM] of clearance from the sensors on
the Ultima Bilge pump to any wall or
surroundings. If there is not enough
clearance, the sensors may detect the
object and leave the pump running
continuously. * **
Maintenance:
The Ultima bilge pump is designed to be
worry free and maintenance free.
However, care should be taken to make
sure that the impeller is clear of debris for
optimum pump functionality. Make sure
power is disconnected during
maintenance of the pump. To access the
impeller, remove pump from strainer by
depressing the side lock tabs on pump
body and pulling pump from strainer. To
clean the impeller, grab on to
impeller guards fins and rotate
impeller guard clockwise and pull straight
out. Remove and clean the impeller and
pump from all debris that has
accumulated. Make sure to clean any
debris that has accumulated on the
strainer as well. After the impeller is clean,
replace impeller guard by aligning tabs
with slots and turning counter-clockwise,
making sure not to over tighten. The guard
should be rotated until it is firm. Place
pump body on to strainer making sure that
both locking tabs snap onto pump body.
Original instructions
Black to negative(-)
Brown to positive (+)
(Manual override)
Brown/white to positive (+)
(Automatic operation)
Depress
(2) tabs
Warranty Information
SPX FLOW Inc. 5885 11th Street
Rockford, IL 61109-3699 warrants to
the original consumer purchaser that this
product will be free from defects in
material and work manship, providing
that the case is not opened or the pump
other wise abused for a period of three (3)
years from the date originally purchased.
> English
Lock impeller guard
by twisting counter
clockwise
9