Precautions; Notice When Using Equipment; Contra-Indications; Storage And Maintenance - CFPM TRI-SCALER Compact Mode D'emploi

Remarks
Remark 1.
Turn the water control knob as the symbol shows. One direction is the minimum with the opposite being the maximum.
Remark 2.
If the scaling tip has been screwed on tightly and there is fine spray too, the following indications my show that the scaling tip is damaged:
- The vibration intensity and the water spray become obviously weak.
- During treatment, a humming sound comes from the scaling tip.
Remark 3.
If the scaling tip has been screwed on tightly and there is fine spray too, the following phenomenon show that the scaling tip is damaged:
• The vibrating intensity and the water spray degree become weak obviously.
• During treatment, it produces the sound like "buzz" from the scaling tip.

1. Notice when using equipment

1. Keep the scaler clean before and after operation.
2. The handpiece, scaling tip, torque wrench, endo wrench and endochuck must be sterilized before each treatment.
3. Don't screw or unscrew the scaling tip and endochuck when stepping on the foot switch.
4. The scaling tip must be fastened and there must be fine spray or drip coming out from the tip when you use it.
5. Change to a new one when the tip and ultrasonic file become damaged or worn excessively.
6. While the scaler is working, the heat of scaling tip will become higher if there is no water flowing out. Please keep the water
flowing smoothly.
7. Don't twist or rub the tip and endochuck.
8. Ensure the connection of the handpiece and the socket of the cable are dry before installing the handpiece.
9. Don't pull the cable forcibly in case of the handpiece falling off from the cable.
10. Don't knock or rub the handpiece.
11. Ensure that the power supply can be easily removed in an emergency.
12. The power supply is considered as a part of the equipment. This device can only be equipped with the special
power supply supplied.
13. The power supply is NOT waterproof. Please keep it dry and away from the water.
14. After operation, turn off power, and pull out the plug.
15. We are only responsible for the safety on the following conditions:
- The maintenance, repair and modification are made by the manufacturer or the authorized dealer.
- The changed components are original of "CFPM" and are operated according to instruction manual.
16. The internal screw thread of the scaling tips produced by some manufacturers may be coarse, rusty or collapsed.
This will damage the external screw threat of the handpiece irretrievably.

2. Contra-indications

This device should not be used in patients with hemophilia.
Patients or practitioners who wear pacemakers should not use this device.
Caution should be exercised when this unit is used on children, pregnant women or people with heart disease.

3. Storage and maintenance

The appliance must be handled carefully, away from vibration and installed in a dry and ventilated place.
Don't store the machine together with the articles that are combustible, poisonous, caustic, or explosive.
This equipment should be stored in a room where the relative humidity is less than 80%, atmospheric pressure is 50 kPa to 106
kPa, and the temperature is -10°C to +50°C.
If not use for a long time, operate the unit with water at least once a month for 5 minutes.

4. Transportation

1. Excessive impact and shake must be prevented in transportation, lay it carefully and lightly and don't invert it.
2. Don't put it together with dangerous goods during transportation.
3. Avoid the sun or getting wet in rain or snow during transportation.
GACD_240614_NoticeTriScallerCompact_V6.indd 8

5. PRECAUTIONS

8
28/01/2015 16:27