Accessories; Service Information - DeWalt D55250 Guide D'utilisation

Compressor Pump oil (Fig. 1)
CHeCkInG oIl
WARNING: Hot surfaces. Risk of burn. Aftercooler, pump head,
and surrounding parts are very hot, do not touch (see the Hot
Surfaces identified in Fig. 2). Allow compressor to cool prior to
servicing.
1. Ensure engine ON/OFF switch (C) is in the OFF Position.
. Place unit on a flat level surface.
3. Remove dipstick (L) and wipe clean.
4. Reinsert dipstick fully into oil fill port for a few seconds to allow
oil to collect on the dipstick.
5. Remove oil dipstick to read oil level. Oil should not exceed top
raised line on dipstick. If oil is below lower mark, add D
synthetic oil and follow Steps 4 - 6.
note: When filling the crankcase, the oil flows very slowly
into the pump. If the oil is added too quickly, it will overflow and
appear to be full.
CAUTION: Risk of Unsafe Operation. Overfilling with oil will cause
premature compressor failure. Do not overfill.
6. Replace dipstick.
CHAnGInG oIl
note: Pump oil contains substances that are regulated and must
be disposed of in accordance with local, state and federal laws and
regulations.
WARNING: Hot surfaces. Risk of burn. Aftercooler, pump head,
and surrounding parts are very hot, do not touch (see the Hot
Surfaces identified in Fig. 2). Allow compressor to cool prior to
servicing.
1. Ensure engine ON/OFF switch (C) is in the OFF Position.
. Allow the unit to cool.
All manuals and user guides at all-guides.com
3. Disconnect spark plug wire.
4. Drain air tank.
5. Locate a suitable container under pump drain plug (J).
6. Remove the dipstick (L) from crankcase.
7. Remove the oil drain plug (M).
8. Allow ample time for all oil to drain out. (Tilting the compressor
9. Install the oil drain plug.
10. Fill pump with D
11. Install dipstick.
1. Reconnect spark plug wire.

ACCESSorIES

WALT
e
Recommended accessories for use with your tool are available
for purchase from your local dealer or authorized service center. If
you need assistance in locating any accessory for your tool, please
contact D
MD 186, call 1-800-4-D
website www.dewalt.com.
CAUTION: The use of any other accessory not recommended for
use with this tool could be hazardous. Use only accessories rated
equal to or higher than the rating of the air compressor.

SErvICE InForMATIon

Please have the following information available for all service calls:
Model Number ____________ Serial Number ___________
Date and Place of Purchase ____________________________
15
towards the drain plug will assist in draining.)
WALT synthetic compressor oil.
e
WALT Industrial Tool Co., 701 East Joppa Road, Baltimore,
e
WALT (1-800-433-958) or visit our
e