Speaker Connection; Care And Maintenance - Marantz MA6100 Mode D'emploi

5. SPEAKER CONNECTION

This sequipment, being a high audio output power ampli-
fier, has a hazardous energy at its speaker terminal. Please
be sure to make an appropriate speaker connection ac-
cording to the following procedures:
* Confirm that the power switch of the equipment is at
"OFF" position. If it is at "ON", turn it to "OFF" position to
connect a speaker cable.
* Use a speaker cable with the flame retardant rating of
Type SPT-2 or more.
* Don't strip the insulation off more than shown in the fig-
ure, at the speaker terminal connection of speaker cable.
Speaker cable (Type SPT-2)
Strip the insulation off the tip of the cord.
Twist the core.

6. CARE AND MAINTENANCE

This section describes the care and maintenance tasks that
must be performed to optimize the operation of your Marantz
equipment.
CLEANING OF EQUIPMENT EXTERNAL SURFACES
The exterior finish of your unit will last indefinitely with proper
care and cleaning. Never use scouring pads, steel wool,
scouring powders or harsh chemical agents (e.g., lye solution),
alcohol, thinners, benzine, insecticide or other volatile
substances as these will mar the finish of the equipment.
Likewise, never use cloths containing chemical substances.
If the equipment gets dirty, wipe the external surfaces with a
soft, lint-free cloth.
If the equipment becomes heavily soiled:
– dilute some washing up liquid in water, in a ratio of one part
detergent to six parts water.
– dip a soft, lint free cloth in the solution and wring the cloth
out until it is damp.
– wipe the equipment with the damp cloth.
– dry the equipment by wiping it with a dry cloth.
7. REPAIRS
Only the most competent and qualified technicians should be
allowed to service your unit. Marantz and its factory trained
warranty station personnel have the knowledge and special
equipment needed for repair and calibration of this precision
instrument.
In the event of difficulty, call the toll-free telephone number
listed on the face of the warranty to obtain the name and
address of the Marantz Authorized Service Center nearest
you. In many cases, the dealer where you purchased your
Marantz unit may be equipped to provide service. Please
include the model, serial number of your unit together with a
copy of your purchase receipt and a full description of what
you feel is abnormal in its behavior.
All manuals and user guides at all-guides.com
* Connect speakers in correct polarity, according to the
* Connect a speaker cable to the speaker terminal in such
* Prevent any stress from being applied to the speaker
* Don't touch the speaker terminals during operation.
Loosen the terminal.
8. TROUBLESHOOTING
The amplifier does not operate and the POWER ON
indicator does not light.
– Is the power cable plugged in properly to the AC power
The POWER ON indicator lights, but the amplifier does
not function.
– Are speaker cables and input cables connected properly?
9. SPECIFICATION
Power output (20 Hz ~ 20 kHz) ................... 125 W 8-ohms
Distortion ................................................................... 0.02 %
Frequency response (-1 dB) ....................... 10 Hz to 70 kHz
S/N ratio (A-weight) ................................................... 110 dB
Damping factor (1 kHz) .................................................... 60
Power supply ............................................. 120 V AC, 60 Hz
Power consumption ................................................... 230 W
Dimensions
Weight ........................................................ 12.6 lbs (5.7 kg)
Accessories
Remote control cable ...................................................... x 1
Design and specifications are subject to change without
notice.
indication for the polarity of speaker terminals.
the condition that the insulated part more than 1.6 mm
of the speaker cable is inserted into the terminal and
that the bare core of the speaker cable is never exposed
outside the terminal.
cable connected to the speaker terminal.
Insert the core.
Connection of speaker cable
outlet?
Width ............................................ 3-1/2 inches (88 mm)
Height ......................................... 5-3/4 inches (146 mm)
Depth ...................................... 18-9/16 inches (470 mm)
Tighten the terminal.
(Stand-by) 2.5 W