Important - Saber R50CC0312 Guide Des Produits

CAUTION
If ignition does NOT occur in 5 seconds, turn the
control knobs OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Main Burner Match-Lighting
Do not lean over grill while lighting.
1. Open lid. Turn ON gas at LP cylinder.
2. Place match into match holder (hanging from left side of
cabinet). Light match; then light burner by placing match
through the match light hole on left side of grill.
3. Push in and turn far left knob to the HI position. Once burner
has ignited (use flame viewing ports to verify), turn control
knob to desired setting.
4. If ignition does not occur in 5 seconds, turn the control knob
OFF, wait 5 minutes, and repeat the lighting procedure.
5. Light adjacent burners in sequence by pushing control knobs
in and turning to the HI position.
Side Burner Ignitor Lighting
Do not lean over grill while lighting.
1. Open sideburner lid. Turn ON gas at LP cylinder.
2. Turn sideburner control knob to the HI position, push and hold
ELECTRONIC IGNITION button.
3. If side burner does not light, turn control knob to OFF, wait 5
minutes, and repeat the lighting procedure.
Side Burner Match-Lighting
1. Open sideburner lid. Turn ON gas at LP cylinder.
2. Place lit match through bottom burner pan hole at the rear of
the burner.
3. Turn side burner control knob to the HI position. Be sure
burner lights and stays lit.
8
Burner Flame Check
Remove cooking grates and emitters. Light burners, rotate control
knobs from HI to LO. You should see a smaller flame in LO
position than seen on HI. Perform burner flame check on side
burner, also. Always check flame prior to each use. If only low
flame is seen refer to "Sudden drop or low flame" in the
Troubleshooting Section.
Turning Grill Off
Turn all control knobs to OFF position. Turn LP cylinder OFF by
turning hand-wheel clockwise to a full stop.
Ignitor Check
Turn Gas OFF at LP cylinder. Press and hold electronic ignition
button. "Click" should be heard and spark seen each time
between collector box or burner and electrode. See
"Troubleshooting" if no click or spark.
Valve Check
IMPORTANT: Make sure gas is OFF at LP cylinder before
checking valves. Control knobs lock in OFF position. To check
valves, first push in control knobs and release, control knobs
should spring back. If control knobs do not spring back, replace
valve assembly before using grill. Turn control knobs to LO
position then turn back to OFF position. Valves should turn
smoothly.
Hose Check
Before each use, check to see if hoses are cut or worn. Replace
damaged hoses before using grill. Use only valve/hose/regulator
specified by manufacturer.
Quick Start Tips
Reversible sideburner grate:
The dual function sideburner grate has a flat surface on one
side for warming, boiling, or frying using pots and pans and it
has a curved surface on the other side for wok usage.
Preheating for different types of grilling:
Sear - preheat with all burners set to HI for maximum cooking
grate temperatures
Barbecue - preheat with all burners set to LO for a lower starting
grate temperature for grilling foods slower.
Indirect grilling - preheat one burner only on the side opposite
where the food will be placed to allow the slowest and lowest
grilling for larger cuts of meat.
Roasting - place the warming rack on the lower supports and
use burner(s) directly under the food on LO or indirectly for lower
temperature cooking. This will allow more heat to circulate
around the food during grilling.
HI
LO