CASUALPLAY prima FIX Mode D'emploi page 18

FITTING THE HOOD (illustrations 1-3)
• Fit the hood by inserting the connectors on both sides into the clips on the sides of the
frame (fg.1).
• Fasten the clasps or the Velcro on the sides to the foot cover (fg.2).
• Make sure that the belt guides on the back part of the backrest are left uncovered (fg.3)
• Remove the hood by following the same steps in reverse order.
CHANGING THE POSITION OF THE HANDLE (illustrations 4-5)
The handle has three positions (fg.4):
A: Handle tilted forward for installation in the vehicle.
B: Vertical as a carrying handle.
C: Horizontal as a rocker or for fitting onto the pushchair.
• To change the position of the handle, simultaneously press the buttons on both sides (fg.5)
and push the handle forwards or backwards until reaching the required position. It will click
into place.
IMPORTANT: To change the handle from position B to C or vice versa, the hood must be
unfolded.
ADJUSTING THE BACKREST (illustrations 6-10)
• Raise the lever on the back of the backrest to adjust the position (fg.6). The backrest will
click into place.
• Bear in mind the baby's weight when choosing the position of the backrest:
A: up to 5 kg. (fg.7)
B: up to 5 kg. (fg.8)
C: from 5 to 10 kg. (fg.9)
D: from 5 to 10 kg. (fg.10)
OPENING AND CLOSING THE HARNESS CLASP (illustrations 11-12)
• Slot the two parts of the chest straps together and insert them into the female part of
the clasp (fg.11). Then press both until they click indicating they are correctly fastened
(fg.12).
• To open the clasp, press the red button.
SAFETY HARNESS (illustrations 13-14)
• Fasten the clasp and tighten the chest straps by pulling the end of the tightening strap
(fg.13), until the required fit is obtained, taking care to always leave some slack.
IMPORTANT: Make sure that the harness straps are not twisted.
• To loosen the harness, press the tightening button and pull the chest straps with the other
hand (fg.14).
16
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR USE