UNITEC Climate W164 Manuel De L'utilisateur page 10

alarm. Bell icon " " appears when alarm is enabled.
Hold "ALARM" to enter alarm time setting mode.
Press "s" or "t" to enter the desired Hr/ Min valu-
es and press "ALARM" to confirm setting.
SNOOZE & BACKLIGHT
When alarm goes off, press "SNOOZE/LIGHT" to
trigger snooze alarm and "Zz" icon will appear. To
stop alarm, press "ALARM" key.
To turn on backlight, press "SNOOZE/LIGHT" or
select "BACKLIGHT" slide switch to "ON" position.
NOTE: Continuous backlight function is only available
when adapter is connected
BLUE LIGHT BAR (NIGHT-LIGHT)
Select "LIGHT BAR" slide switch to "ON" position
to turn on the blue light bar (night-light) continuous-
ly (This function is available only when adapter is
connected).
Select "LIGHT BAR" slide switch to "OFF" position
to turn off the light bar.
IMAGE PROJECTION
To project time image onto wall or ceiling, press
"SNOOZE/LIGHT" button or select "PROjECTION"
slide switch to "ON" position.
Select "PROjECTION" to "OFF" position to turn off
continuous projection
Rotate the "FOCUS" knob to adjust the image
focus.
Rotate the "IMAGE ROTATION" knob to adjust the
orientation of the projected image
NOTE: Continuous projection function is only availab-
le when adapter is connected
LOW BATTERY INDICATION
Low battery indication is available for the home unit
itself and all of the 3 remote channels. Replace the
batteries and follow the setup procedure in this
instruction manual.
English
313510_W164_Manual.indd 10
All manuals and user guides at all-guides.com
BATTERY DISPOSAL
Replace only with the same or equivalent type
recommended by the manufacturer.
Please disposal of old, defective batteries in an
environmentally friendly manner in accordance with
the relevant legislation.
SPECIFICATIONS
Indoor unit: 0 C to + 50 C (+32 F to +122 F)
Remote sensor: -20 C to +60 C (-4 F to +140 F)
Transmission: up to 30M (98 ft.) in open area,
RF434 MHz
Temp Resolution: 0.1 degree C (or 0.2 degree F)
Clock: DCF77 Radio-Controlled, Quartz back-up
Power: 4.5V adapter & AAA x 3 pcs for projection
clock
AAA x 2 pcs for remote sensor
10
25.11.09 10:12