Table Des Matières; Preparing The Remote Control; Supplied Accessories; Making The Connections - Panasonic SC-HC25 Manuel D'utilisation

Table of contents
IMPORTANT SAFETY INSTRUCTIONS ............ 3
Listening caution ............................................... 3
Product service.................................................. 3
Preparing the remote control ........................... 4
Supplied accessories ........................................ 4
Making the connections .................................... 4
Overview of controls ......................................... 5
Discs ................................................................... 6
Using an iPod or iPhone ................................... 7
Radio ................................................................... 8
Clock and timers................................................ 8
Sound effects ..................................................... 9
External equipment ........................................... 9
Remote control code ......................................... 9
Troubleshooting guide ...................................... 9
Maintenance ..................................................... 10
Specifications .................................................. 10
Limited Warranty ..............................................11

Preparing the remote control

Use alkaline or manganese battery.
Install the battery so that the poles (+ and -) align with those in the
remote control.
Point the remote control at the remote control sensor (Z 5), away from
obstacles, at a maximum range of 7 m (23 feet) directly in front of the
main unit.
CAUTION!
• Do not break open or short-circuit the battery.
• Do not charge the alkaline or manganese battery.
• Do not use the battery if the cover has peeled off.
• Do not heat or expose to flame.
• Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
• Mishandling of battery can cause electrolyte leakage, which can
cause a fire.
• Remove the battery if you do not use the remote control for a long
period of time. Keep in a cool, dark area.
CAUTION!
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's
instructions.
4
4
All manuals and user guides at all-guides.com
(not included)

Supplied accessories

Check and identify the supplied accessories.
Use numbers indicated in parentheses when asking for replacement
parts. (Product numbers correct as of January 2011. This may be
subject to change.)
To order accessories, call the dealer from whom you made your
purchase.
1 x AC power supply cord
(K2CB2CB00021)
1 x FM indoor antenna
(RSAX0002)
The included Canadian French label sheet corresponds to the English
printing on the main unit.

Making the connections

Conserving power
The system consumes approximately 0.1 W when it is in standby mode.
Disconnect the power supply if you do not use the system.
Some settings will be lost after you disconnect the system. You have to
set them again.
1
Connect the FM indoor antenna.
Place the antenna where reception is best.
2
Connect the AM loop antenna.
3
Connect the AC power supply cord.
Use the included AC power supply cord with this system only.
Do not use an AC power supply cord from other equipment.
Note:
• These speakers do not have magnetic shielding. Do not put them
near TVs, PCs or other equipment easily influenced by magnetism.
• You cannot remove the net of the speakers.
1 x AM loop antenna
(N1DYYYY00010)
1 x Remote control
(N2QAYB000640)
Adhesive tape
Click!