How To Operate; Helpful Tips - NOSTALGIA PRODUCTS CLFRZFRTSHVR2AQ Instructions Et Recettes

HOW TO OPERATE

1. If you haven't yet, fill a standard ice cube tray or the supplied Ice Molds with water,
juice, fruit of choice and place in freezer until frozen. Remove ice trays or molds
from freezer. See HELPFUL TIPS section for instructions on using the Ice Mold.
2. Place the ELECTRIC SHAVED ICE & SNOW CONE MAKER on a stable, waterproof
surface near an electrical outlet before starting. DO NOT PLUG INTO OUTLET.
NOTE: Always make sure that the cord is away from a water source.
3. Carefully remove Ice Holding Box and place ice cubes or ice mold
inside. Then slide Ice Mold House back into place.
NOTE: If using Ice Mold Disk allow ice to soften (5-15 minutes). It is
very important to allow the ice to soften naturally. DO NOT put in
microwave or any other heating elements to help soften ice disk.
USE CAUTION when placing ice cubes in Shaver Bowl. The blade in the Shaver Bowl is
very sharp.
4. Once softened, place the Ice Mold or a small bowl under the Shaver onto the Base
to catch shaved ice and then place the Ice Holding Box into the main body.
5. Using the Turn Knob, turn the downwards to lower the Ice Mold
Place Holder into the ice mold until there is resistance.
At this time PLUG UNIT INTO OUTLET, then press the Power
6.
Button to begin ice shaving. NOTE: You may need to turn the wheel
downward as Ice Mold thins to continue shaving action.
7. Once ice cubes or ice mold is too thin to cut you may add more ice and continue
process. To do so, first UNPLUG UNIT and then add more ice. NOTE: Some ice
may remain in the Shaver Bowl. Discard this ice before adding more ice.
8. Once more ice has been added plug unit back in and continue. Repeat
this process until you have the desired amount of shaved ice.
9. After each 1 minute of continuous use, wait 10 minutes
before using again to allow Motor to cool.
10. Unplug unit from outlet when finished.

HELPFUL TIPS

USING ICE MOLD
Common ice cubes may be used in the ELECTRIC SHAVED ICE &
SNOW CONE MAKER, but will produce slightly coarser textured ice.
For best results, we recommend using the included Ice Mold.
• Fill the supplied Ice Mold with liquid to approximately
½ inch below the top, just below the Max fill line.
• Place on a flat surface in the freezer until frozen (about 10 - 12 hours).
• If unable to remove ice from Ice Mold, run under water until ice is loose.
• Ice Mold makes approximately 2 cups of shaved ice.
• Ice Mold can also be used as a serving bowl for shaved ice.
6