Functions; Operation; Connect The Evap - Brink 614687-F Manuel

The Evap controller controls the Evap system module based on the relative humidity
(RH) and temperature measured in the room, therefore the controller must present in
the room where you want the RH to be controlled.
The following are shown on the display of the Evap controller:

Functions

-
Humidify (HUMIDIFY). Cool (Cool) or both (AUT) is not applicable for the Brink
Evap
Status
-
batteries, RF connection and control.
1.1

Operation

The Evap controller communicates with the Evap system module via a wireless RF signal (868MHz). Based on
the (pre-)set values (setpoints) the controller sends a signal to the Evap that responds to this. The (pre-)set
values (setpoints) can be adjusted by the user.
N.B.! The display switches off automatically after 8 seconds to optimise the battery life. The controller connects
3 times per hour to the Evap system module to update the measured values and to adjust the humidification
control to this.
1.2

Connect the Evap

To connect the Evap controller to the Evap system module the following steps must be followed::
Evap controller
1. Remove the back of the Evap controller by unscrewing the small screw
on the bottom and carefully removing the back from the front.
2. You can now see the back of the PCB. There is a pushbutton on this,
see blue arrow.
Evap system module
3. On the bottom of the Evap system module is a small opening level with
the lock symbol on the sticker on the bottom.
4. Push in the button in this opening (using a paperclip) for 1 second.
5. The Power LED will flash (1 seconde on/1 second of).
Evap controller
6. Then push in the button on the back of the Evap controller (blue arrow). A green light will briefly flash.
7. Check that the connection between the controller and the system module has been made by pressing
on 'MODE' button
8. In the top left of the display the RF symbol
Section 1 - Operation
should now be visible.
Evap controller
1
Backside of controller
1