Rear Panel Overview - Numark IDEC Guide D'utilisation Rapide

REAR PANEL OVERVIEW

3
6
1. POWER INPUT – Use the included power cable to connect this input to a power source.
2. USB PORT – Use a USB cable to connect the iDEC to your computer. Connecting the iDEC to your computer
allows you to sync your iPod to your iTunes music library. See "Syncing your iPod through the iDEC" section
for detailed information.
3. AUDIO OUTPUT – Use the included RCA cable to connect this stereo output to the audio input of your power
amplifier, mixer, or speakers system.
4. S-VIDEO OUTPUT – Use an S-Video cable to connect this output to a TV or projection system to display video
content from a video-compatible iPod.
5. VIDEO OUTPUT – Use an RCA cable to connect this composite video output to a TV or projection system.
6. RECORD INPUT – Use an RCA cable to connect external line-level devices, such as mixers, to this input.
Incoming audio can be recorder directly to a compatible iPod (see "Recording to iPod" section for more
information).
THE TWO MODES
The iDEC features two modes of iPod operation: Direct and USB.
In Direct Mode, you can:
control your iPod via the integrated controls
play audio and video content from your iPod
record audio from external sources to your iPod
In USB Mode, you can:
synchronize and transfer music between your iPod and your computer's iTunes music library
Note that the integrated controls will be disabled until you switch over to Direct Mode.
DIRECT MODE
AUDIO
AUDIO
PLAYBACK
RECORDING
If a USB cable is connected to your computer and you place your iPod in the dock, the iDEC will
automatically enter USB Mode and the iPod will connect to your computer. The screen of your iPod will
display "Do Not Disconnect". Please do not remove the iPod from the dock while you are in USB Mode. To
safely remove the iPod, the iDEC needs to be in Direct Mode.
To switch from USB Mode to Direct Mode, first eject the iPod from the iTunes interface, then press and hold
EJECT on the iDEC for 5 seconds. While in Direct Mode, it is safe to remove the iPod from the dock.
While an iPod is still docked and the USB cable is connected to your computer, you can switch from Direct
Mode back to USB Mode by holding EJECT for 5 seconds.
4
5 2
VIDEO
SYNC &
PLAYBACK
TRANSFER
iPod
CONTROL
AUDIO
PLAYBACK
RECORDING
3
1
USB MODE
VIDEO
AUDIO
PLAYBACK
iPod
CONTROL
SYNC &
TRANSFER