Mounting Instructions; Front Panel Overview - Numark IDEC Guide D'utilisation Rapide

MOUNTING INSTRUCTIONS

FRONT PANEL OVERVIEW

1
1. POWER – This button turns the unit on and off. Power off the unit when not in use for extended periods of
time. The LED also functions as a clip indicator when recording audio; if the LED turns yellow, this means that
the input signal is too "hot" and that you should turn down the output volume of your external device.
2. iPod DOCK – Connect your iPod to this dock. Please make sure that your iPod fits snuggly over the dock
connector but do not force it! The dock allows you to play back music from your iPod through the AUDIO
OUTPUT connections on the rear panel, or to record audio from external devices connected to the RECORD
INPUT directly to your iPod. Please refer to the table below for information on iPod compatibility:
Note that the iDEC can also
charge your iPod while it is
docked. When not recording, the
iDEC will automatically charge
your iPod. When
recording, charging
disabled to ensure the best audio
quality and to prevent unwanted
noise from entering
recordings. We do understand,
however, that you
recording long sessions which
require your iPod
charged for longer periods of time.
While recording, you can turn on
iPod charging by pressing |<< and
>>| simultaneously. You can turn
it off at any time by pressing |<<
and >>| again.
3. MENU – This buttons functions as the 'MENU' button of your iPod.
4. JOG WHEEL – This wheel functions as the touchwheel control of your iPod.
5. ENTER – This button functions as the 'ENTER' command of your iPod.
6. |<< - This button functions as the '|<<' button of your iPod.
7. >|| - This button functions as the '>||' button of your iPod.
8. >>| - This button functions as the '>>|' button of your iPod.
9. EJECT – Hold this button for 5 seconds to switch between USB Mode and Direct Mode (see "The Two Modes"
section for more information). While the iDEC is in USB Mode, please ensure that you always safely eject your
iPod from the iTunes interface, then hold the EJECT button the iDEC for 5 seconds to switch to Direct Mode.
While in Direct Mode, it is OK to remove the iPod from the dock at any time. Please do not remove the iPod
from the dock while the unit is in USB Mode and "Do Not Disconnect" is displayed on the screen; doing so may
damage your iPod and its contents. If you wish to reestablish the connection to your computer while the iPod is
docked, you can press and hold EJECT for 5 seconds.
This device may be mounted in a standard 19" rack taking up 2
spaces. Please use 4 rack screws (not included) to secure the unit to
the rack.
3
2
iPod Model
iPod
Classic
5th generation
you are
will be
4th generation
3rd generation*
1st and 2nd generation
your
iPod Nano
3rd generation
may be
2nd generation
to remain
1st generation
iPod Shuffle
iPod Mini
iPod Touch**
rd
* On 3
are supported. Buttons "Select", "Menu", and "Rec Mode" are unsupported.
** On iPod Touch, only music player navigation is supported.
5
4
generation iPod, only the buttons "Play", "Rewind", and "Fast Forward"
2
8
7
6
Playback
9
Record