Recode All The Detectors; Adding More Sensors; Arm/ Disarm By Keypad On Main Panel - Samba DSD EVOLU 7 Line Guide D'utilisation

remote controller etc. It means the detector is coded sucessfully when
you hear a "DI" beep.
4) Following the same coding process above 1) 2) 3), user could
continue to code more sensors in same zone or different zones before
the device exit coding mode.
Remark:
a. When the system is Armed away , whatever the detectors are coded
in arm out or arm at home mode, all of them make alarm when
triggered;
b. When the system is Armed at Home, only the detectors coded in
Arm at home mode make alarm when triggered; others coded in "Arm
Out" mode don't make alarm.
c. Usually suggest users to code the door contact sensors in Arm at
home mode, code the PIR sensor in Arm Out mode. All the door
sensors can make alarm when activated, but PIR sensor not when Arm
at home in the night.
d. Users can code detectors and remote controllers by following above
steps.

3.5.4 Recode all the detectors

If the device has exited coding mode, press the code key to enter code mode as
per point 3.5.1, then repeat the code process above, the main panel would only
recognize the new registered, the others would be lost automatically.

3.5.5 Adding more sensors

If the device has exited set mode, but user want to add more detectors but don't
remove the existing , just press "Code" key lightly(no di sound), and release it
immediately, and then press the "Code" again for about 4s to 5s. After one beep,
release the key, the system is in coding status of more sensors. The coding
process is the same as above description. After finishing coding, Press "Code"
key again, the main panel ends coding process with two "Di...Di" beeps, the
previous code still remained.

3.6 Arm/ Disarm by keypad on main panel

A password (Default 1234) is requested to input if users would like to Arm Out,
Arm Home, Disarm the system by keypad on main panel. The main panel voice
a long "Di" to confirm it if password is correct, otherwise voice three "Di Di Di"
to remind the password you input is incorrect.
a. Out Arm: After input correct password, please press "Out" button on main
panel, out LED blinks about 25s, then armed (delay arm) with a "Di" beep.
Pressing Out Arm followed by SOS alarm button immediately would get into
arm status at once (instant arm).
b. Home Arm: After input the correct password, please press "Home" button on
main panel, home LED blinks about 25s, then armed at home with a "Di" beep.
-- - 34 --