Samba DSD EVOLU 7 Line Guide D'utilisation page 29

b. For liquid oil gas, which is a bit heavier than air and sink down to a lower level,
the gas detector should be installed above 0.3—1.2meters and 1.5meters near gas
sources.
Pay much attention to the following items when installing:
a. Don't opposite to the gas smoke or steam
b. Don't leave the position where there is floating air
c. Don't make it been covered by curtain or cupboard.
d. Don't be installed in the wet place such as bathroom or steam room.
When working with alarm system together, you can press the test button to make
sure it can check code with control system.
III. Guide of Use.
Reheat statement:
Connecting AC 200V, or 110V, the green indicted LED flash that shows that the
gas detector is in the statement of reheat:
Controlling and surveillance statement:
After 3 minutes, the green LED is on that shows that the detector is in the
surveillance statement.
Alarm statement:
The buzzer sounds emergent alarm with red LED on when the concentration of
gas up to the alarm concentration
IV. Back to the original statement
Alarm will be stopped when the concentration reduced under the required point.
V. The process of alarm: How to do when alarming?
Answer:
a. Shut the brake of gas channel.
b. Open all windows and doors to set the gas out.
c. Don't turn any electronic switch, cell phone or door bell, which can be very
dangerous and possible to make a fire.
d. Don't use match or lighter; At the same time, cut all fire source.
e. Don't seek for the fire source with fire and don't cut the power of gas detector,
because it will stop alarming after leaked gas disappears.
f. Find out the reason of gas leak and notice gas supplier to maintain it.
-- - 29 --