Installation Of Wireless Outdoor Siren - Samba DSD EVOLU 7 Line Guide D'utilisation

IV. Test and Maintenance
When testing, press the test button (the black point on the side) and last two
second. It shows that it is working normally when the gas detector sound loud
and clear alarm, the red LED flashing. You also can put smoke into the inside of
detector, and you will hear clear and silvery pulsant signal.( Test once per week
to make sure it works well)
Simple maintenance:
Clean it every 6 months. Cut off the power before cleaning; Clean the dust with
soft brush and then turn on the power.
Something important when cleaning.
a. Don't wash directly it with chemical
b. Don't use excitant substance such as fixature, oil paint, plenty of wine.
c. It is forbidden to clean with water or wet inside.
d. Don't break or separate the gas detector.

2.5 Installation of wireless outdoor siren

Please test the outdoor siren before installation. Then, fix the outdoor siren on the
wall, and then connect with DC12V power supply. Please don't put it under rain
directly.
Note: We have coded the alarm host with the siren in the kits already before
delivery, so there is no need to recode before use. You may lose the signal.
If (and only in such situation), after installation, the siren cannot work, please
follow this process:
Firstly, you need to delete coded information. Just press the black button for 4s, a
long beep will sound confirming deletion.
Then the connection of the siren and the alarm will be deleted. You need to code
them again.
-- - 30 --