Maintenance; Cartridge Replacement; Care And Cleaning - Westinghouse QK045 Manuel De L'utilisateur

Maintenance

CARTRIDGE REPLACEMENT

If the cartridge needs to be replaced in the future, follow these
instructions to replace it:
- Turn off the water supply to the faucet at the closest shut off valve .
- Remove the lever (2) by loosening the screw (1) with a hex
wrench. The cartridge nut (3) will then be exposed.
- Carefully remove the cartridge nut (3) with a wrench to reveal the
cartridge (4).
- Remove the cartridge (4) and replace it with a new cartridge.
- Screw the cartridge nut (3) and washer (5) back on and replace
the handle lever (2), tightening it in place with the screw (1) using
a hex wrench.

Care and Cleaning

Your sink is manufactured with the highest grade stainless steel and will provide you many years of enjoyment with the proper care .
Do
- After use, always rinse your sink with tap water to dilute and
remove deposits .
- Towel dry the sink after use whenever possible to prevent water
spots . Should water spots occur, clean with a mild solution of
vinegar and water followed by a thorough rinse .
- Use liquid soap, a general household cleaner,
or a weak solution of vinegar and water for
regular cleaning .
- Only use plastic scouring pads recommended for use in stainless
steel sinks, and only use them in the bowl of the sink . Scrub in the
direction of the satin finish lines.
SCRATCH, SPOT, AND BLEMISH REMOVAL AND SURFACE RESTORATION:
Little rust spots and blemishes that periodically appear in the sink are typically the result of the steel interacting with the chemicals found in the vast spectrum
of substances that sinks are commonly exposed to. They may also get transferred from other objects placed or left in the sink. Scratches are the result of regular
wear and tear .
To remove scratches, spots, and blemishes from the sink, rub them with a non-metallic scouring pad (e.g. Scotch-Brite
(e.g. Vim ). Always rub the surfaces in the direction of the grain of the steel. When finished, rinse the sink with water and dry it with a towel
® or Barkeeper's Friend ®
to allow the sink to form a protective outer layer . This procedure can also be used to renew all of the surfaces of the sink .
All manuals and user guides at all-guides.com
9
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
Do Not
- Do not allow any food, detergent, soap or grease to dry or sit
for extended periods of time on the surface of the sink.
- Never use abrasive cleaning products, as they will dull and
scratch the finish.
- Do not use scouring pads on the deck, as they will dull the
mirror finish.
- Never use steel wool pads, as they will leave iron particles on
the sink, which will cause corrosion .
- Never leave mild steel or cast iron pans in your sink for
extended periods of time, as this can cause corrosion.
) combined with a mild abrasive cleaner
®
2
1
3
5
4
CONGLOMKB .COM