Soap Dispenser - Westinghouse QK045 Manuel De L'utilisateur

Installation (continued)
INSTALLING THE FAUCET AND THE SPRAYER
- It is best to install the faucet before mounting the sink .
- Insert the neck (1) into the body (2) of the faucet and hand
tighten the retaining collar until it is snug .
- Insert the sprayer housing support (3) through the pre-
drilled hole in the corner of the sink (A) and hand tighten
the nut (4) to secure it.
All manuals and user guides at all-guides.com
1
2
3
4
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
- Run the sprayer hose (5) down through the sprayer housing
support (3) and up through the central faucet mounting hole.
Connect the sprayer hose (5) to the body (2) and tighten with a
wrench. DO NOT OVER-TIGHTEN.
- Install the body (2) onto the sink (A) with hot to the left and
cold handle to the right. From under the sink (A), thread the
mounting nuts (6) with washer (8) onto the faucet shanks (7).
Hand-tighten the mounting nuts .
7
8
6
INSTALLING THE SOAP DISPENSER
- Insert the dispenser assembly (2) and pump top
(1) through the pre-drilled hole on the top surface
of the sink (A).
- From the bottom of the sink, insert the bottom
gasket (3) and lock nut (4) through the dispenser
assembly (2). Hand tighten.
- Screw the soap reservoir (5) into the dispenser
assembly (2) to complete the installation.
- To fill the reservoir, lift the pump top (1) straight
up to remove it from dispenser assembly (2).
Carefully pour in liquid soap to fill the reservoir,
then replace pump top .
CAUTION: This unit is designed for use with
household liquid soap only . Using any other
soap or chemicals in this unit may damage the
dispenser and void the warranty .
7
2
5
A
5
CONGLOMKB .COM
1
2
A
3
4
5