Kicker KM6250.2 Manuel Du Propriétaire page 4

WIRING
Carefully place the speaker wire in a location that is clear of standing water and moving components of
the vessel. For reference, the Blue wire is Positive and the Grey wire is Negative. Mount the crossover to
the woofer's back plate with the enclosed phillips-head M3 stainless steel machined screws, or mount
the crossover remotely in a location free and clear of standing water. The locking crossover cover with
water resistant gasket is removable for wiring installation; it helps prevent terminal corrosion and electrical
shorting. The positive and negative gold plated terminals are of different sizes and correspond to the
appropriate gold plated positive and negative wire connectors. Take off the crossover cover, and connect
the wire from the woofer to the "WF" terminal and the wire from the tweeter to the "TW" terminal. Connect
the supplied 15 feet (4.5m) of wire to "IN" terminal in the crossover. Carefully route the wires through the
slot between the crossover and crossover cover, and snap the crossover cover back on the crossover.
Connect the other end of the heavy gauge wire to your amplifi er in accordance with its owner's manual.
Source Unit or Amplifi er
4
2009 KM Components Multilingual c01.indd 4 2009 KM Components Multilingual c01.indd 4
All manuals and user guides at all-guides.com
Integrated moisture draining system
KMCOMPONENTSYSTEM
Crossover Cover
Slot
11/21/2008 3:38:11 PM 11/21/2008 3:38:11 PM