Yakima CaddyYak Instructions De Montage page 14

10
ATTACH THE TWO REFLECTORS.
Insert the reflector's screw into the grommet
at the lower rear section of the trailer.
• Tighten with a 8 mm wrench or a screwdriver.
11 INSTALL HITCH ARM TO TRAILER.
Insert the tube end into the side bumper labeled "HITCH".
• Align the holes in the bumper and in the arm.
• Insert the attached pin into the aligned holes.
• Pull the clasp over the end of the pin.
ATTACHING THE TRAILER TO YOUR BIKE...
A bike towing a trailer has to work extra hard.
Like its rider, the bike needs to be well
maintained and kept in sound working order.
Always use a bike in good operating condition
with a set of brakes that can safely stop both
bike and loaded trailer. Perform safety checks
1033077B-14/38
8 mm
Test the hitch arm installation by
pulling and twisting the arm. If it
comes out, repeat the installation.
on a regular basis and address all maintenance
concerns as they arise. Avoid problems by
planning ahead and addressing them before they
become a hazard to safe travel. If you have any
questions or need help seek the knowledgeable
assistance found at your local bicycle shop.
14