Symbols - Jaga BRIZA 12 038 Instructions D'installation

Installation
The device must be installed by a certified installer in accordance with this manual and the national
and local building and safety regulations. An improper installation may lead to product failure, redu-
ced performance, vibrations or higher noise level.
– The device may have sharp edges; wear suitable protective clothing during the installation/
maintenance.
– All dimensions specified in the manual must be respected to guarantee the performance of the
device and to allow installation and maintenance. Provide some extra room if valves are to be
installed.
– Ensure that vibrations cannot be transferred between different elements by using contact noise
insulation.
– With cooling: insulate the hydraulic pipes .
– When the condensate drain pipes are being connected, the pipe system must be sufficiently
supported in order to prevent strain on the condensate drain tray.
Device installation guidelines :
– Wall-/ceiling unit: wall/ceiling on which the device is installed must be perfectly flat and sturdy
enough to carry the device's weight and must not contain any pipes or electrical wires.
– No obstacles in the immediate area that can hinder the airflow .
Starting :
(Re)starting and commissioning the device must be done by professional and qualified person-
nel. Check beforehand if the device is correctly installed:
– The device is correctly installed .
– The supply and return pipes are correctly connected- in case of cooling - insulated .
– The pipes are clean and the air removed.
– The ventilation grilles, coils and condensate drain are clean .
– The wiring connections are correctly and properly tightened .
– The supply voltage is correct .
Let the device run at the highest setting for at least 3 hours and check for deviations.
2. SYMBOLS
Danger
Danger: electrical hazard
Danger: sharp edges / components
Danger: hot surfaces
Danger: moving parts
Attention: important warning
Enviromental safeguard
JAGA NV | BRIZA 12 - STAND ALONE / BUILT-IN | MANUAL | 2021.04.01 | V.12
VDC - direct current
VAC - alternating current
EN
41