Tripp-Lite DU3VN Serie Manuel Du Propriétaire page 7

Digital Load Meter
2 If you press and hold this button
for 4 seconds you can display the IP
Address assigned to the unit in the
LED Amps display
is no address assigned. If this is
the case, "no address" will display,
one letter at a time. If there is an IP
Address programmed, the address will
display 1 digit at a time with dashes (-)
representing dots or periods (.).
Features
NEMA 5-20R
21-03-394-933038.indb 7 21-03-394-933038.indb 7
B
. The default
C
Outlets: During normal operation, the outlets distribute AC power to
connected equipment.
Cord Retention Bracket: Provides secure attachment points for
connected equipment cords.
Mounting Brackets: Use these brackets to mount the PDU.
SNMP Reset Button: Press the reset button for 3 seconds to reboot the
PDU's network card. Rebooting the network card will not erase network
settings or interrupt AC power.
PS/2 Port: Use this port to connect a Tripp Lite ENVIROSENSE
environmental sensor to provide remote temperature/humidity monitoring
and a dry contact interface to control and monitor alarm, security and
telecom devices. Visit www.tripplite.com for ordering information.
Note: Do not connect a keyboard or mouse to this port.
RJ-45 Modem Port: Reserved for future use.
F
E
D
7
B
C
A
4/1/2021 11:22:43 AM 4/1/2021 11:22:43 AM