WEPA TOPITEC AUTOMATIC Mode D'emploi page 96

6 . O P ER AT IO N
6.1 Connection to power supply, interfaces
1. RS 232 interface
2. Fuse holder for
slow-acting 1A fuse
3. Power switch
(main switch)
4. Fuse holder for
slow-acting 10A fuse
5. Power socket
(3-pin)
The rear panel of the TOPITEC
1. RS 232 interface
for the printer connection (see 6.2)
2. Fuse holder (recessed) containing 1 slow-acting 1A fuse.
3. Main switch (power switch)
When this switch is ON, the TOPITEC
is powered from the power mains.
4. Fuse holder (recessed) containing 1 slow-acting 10A fuse.
5. Power socket (3-pin)
with phases including PE conductor; socket for IEC-60320 C13/C14 cable plug. The power
cable must be connected to a properly earthed power socket with a PE conductor.
30
TOPITEC ® AUTOMATIC User Manual | 12-2020
Warning
The TOPITEC ® AUTOMATIC must only be operated by instructed personnel
who have been trained in its functions and control.
Note
Before starting production, ensure that there are no objects (e.g. tools,
residual material, etc.) on or near the TOPITEC
AUTOMATIC features the following control devices and ports:
®
AUTOMATIC
®
Warning
If the main switch needs to be switched off for cleaning, maintenance
or repair work, always disconnect the power cable from the power socket
(to prevent inadvertent switching on).
AUTOMATIC mixing system.
®
Fig. 1-3 Power connection,
interfaces, fuse holders