WEPA TOPITEC AUTOMATIC Mode D'emploi page 104

M IX I NG MO DE /
PR EPAR AT ION S E T UP (O NCE- O FF)
1.
2.
3.
38
TOPITEC ® AUTOMATIC User Manual | 12-2020
1. If you wish to process a formulation that you do not require at
any later stage, you have the option to adjust the default set-
tings according to your requirements without the need to save
these settings. To do this, press
display, indicating that you can now adjust the time. To do this,
press the buttons as required.
+/–
Press the button. "rpm" flashes on the display, indicating
Set
that you can now adjust the speed.
To start production, press the
2. The slide moves to its end position, and the message to the left
is shown on the display:
The TOPITEC AUTOMATIC guides the tool shaft into the drive
®
shaft sleeve automatically and locks it in position. After a short
run-up time of the torque motor, production starts with the
user-defined settings.
The speed and time remaining until the end of the mixing
process is shown on the display.
The TOPITEC AUTOMATIC display also shows a number
®
(1 to 99) referred to as the production number. It is generated
automatically and shown during the entire production time in
the top right corner of the display (here: 11).
3. "rpm" flashes on the display, indicating that you can
adjust the speed throughout the mixing process by means
of the / buttons.
+ –
2x. "min." flashes on the
Set
button.
I/0