Enabling the low-power mode
Performing a system reset
All manuals and user guides at all-guides.com
Your Wave
®
music system has a low-power mode which causes the system to use less
energy after you turn it off. If the low-power mode is enabled, the display automatically turns
off after 30 minutes. Just before the display goes blank, LOW POWER- ON is displayed.
In the low-power mode, the clock still runs normally, presets are maintained and if an alarm is
set, the system turns on at the programmed alarm time. While in the low-power mode,
pressing FM/AM, CD, AUX or Preset 1 to 6 turns the system ON in the normal way. Pressing
any other remote key, or one that does not turn the system on, lights up the display for
another 30 minutes and then turns it off again.
1. Press and hold Alarm Time (Menu) until -SETUP MENU- is displayed.
>
2. Press Tune/MP3
eight times until LOW POWER- OFF is displayed.
3. Press Time – or Time + to change LOW POWER- OFF to LOW POWER- ON.
4. Press Alarm Time (Menu) to exit the set-up menu or wait 10 seconds for the
set-up menu to end automatically.
If you wish, you can restore your Wave
1. Press and hold Alarm Time (Menu) until -SETUP MENU- is displayed.
>
2. Press Tune/MP3
nine times until RESET ALL- NO is displayed.
3. Press Time + to change RESET ALL- NO to RESET ALL- YES.
4. When PRESS 2 TO CONFIRM appears on the display, press Presets button 2. When
the reset is complete, DEFAULTS RESET is displayed.
5. Press Alarm Time (Menu) to exit the set-up menu or wait 10 seconds for the set-up
menu to end automatically.
Personalising Your Wave
®
music system to the original factory settings.
®
Music System
25