Assembling Instructions - Gloria Airstar Stratos 5 Mode D'emploi

preferably by the manufacturer. Re-
pairs to the tank are not permitted.
● Repairs should only be carried out
by Brill GLORIA Service Stations.
● Clean tank thoroughly immediately
after use and then dry completely.
● As far as possible, apply environ-
mentally harmful agents as close to
the target as possible (direct appli-
cation), and store any unavoidable
residue in an appropriate container
until it can be properly disposed of.
● Attention!
Regarding the law of product liability,
we particularly point out that we are
not liable for damages caused by
our device as far as these damages
have been caused by improper re-
pair or by a part replacement when
Brill GLORIA original parts are not
used, and when the repair has not
been carried out by the after-sales-
service or by an authorized expert.
This concerns the accessories, too.
Assembling
instructions
● Fig. A: Install the spray tube into the
quick-action valve.
● Fig. A*: Screw the hose into the
quick-action valve.
● Fig. B: Guide the diagonally-cut
riser tube 1 into the small connect-
ing hole in the cover of the tank and
press it down firmly. Push the hose
connecting nut up to the first thread
of the connector and tighten it up
carefully. Finally, press the hose into
the hose holder 2 in the filler funnel.
● Fig. C: PRO 5/8 spray units
Insert the safety valve into the large
connecting hole in the cover of the
tank and tighten it up carefully.
*Some units are equipped with a differ-
ent type of quick-action valve that has a
built-in hose.
Assembly of carrying strap:
PRO 5, AIRSTAR STRATOS 5
● Fig. D
Carrying strap to be fixed onto sus-
pension hooks of the tank with the
inside punchings. In order to secure
the hold, the excess end is to be
bended and fixed with the outside
punchings.
11