GPO PR100 Mode D'emploi page 12

TURNTABLE
INSTALL THE TURNTABLE
1. U npack your GPO PR100 and remove the platter from its
cardboard box.
2. E nsure that the elastic band around the interior rim of the platter is
not twisted and that it is flush with the platter's base.
3. Unpack the base unit and place it on a flat, stable surface.
4. H olding the platter with the flat side down, place a finger through one
of the larger holes and stretch the elastic band around this finger
(see image below left).
5. H olding the platter with the flat side up, place a finger through the
same hole and stretch the elastic band around this finger. This will
help you attach it to the drive shaft. Hold the band securely with your
finger and thumb (see image below right).
6. G ently lower the platter onto the central spindle of the base unit,
ensuring that the elastic band is stretched over the drive shaft.
12
GPO PR100_user_Manual EU_v4 - Sept 2021.indd 12 GPO PR100_user_Manual EU_v4 - Sept 2021.indd 12 28/09/2021 12:47 28/09/2021 12:47