Ninja NN210C Instructions page 7

39 Upon completion of processing, ensure
that the blade assembly is removed
BEFORE emptying container's contents.
Remove the blade assembly by carefully
grasping the top of the shaft and lifting
it from the container. Failure to remove
the blade assembly before emptying the
container results in a risk of laceration.
40 Remove the Pro Extractor Blades
Assembly from the High-Speed Blender
cup upon completion of blending. DO NOT
store ingredients before or after blending
them in the cup with the blade assembly
attached. Some foods may contain active
ingredients or release gases that will
expand if left in a sealed container, resulting
in excessive pressure buildup that can
pose a risk of injury. For ingredient storage
in the cup, use only Spout Lid to cover.
41 If the appliance overheats, a thermal switch
will activate and temporarily disable the
motor. To reset, unplug the appliance
and allow it to cool for approximately 15
minutes before using again.
SAVE THESE INSTRUCTIONS
42 The maximum wattage rating for this
appliance is based on the configuration
of the Pro Extractor Blades Assembly
and High-Speed Blender cup. Other
configurations may draw less power or
current.
43 DO NOT process dry ingredients without
adding liquid to the High-Speed Blender
cup. The High-Speed Blender cup is not
™
intended for dry blending.
™
44 The Blade Discs are sharp. Always use the
handles on the side of each Blade Disc
when placing it into the Bowl or removing
it. Follow all cleaning instructions. Failure to
do so will result in a risk of laceration.
45 When using the Spiralizer, ALWAYS use
the Food Pusher. NEVER feed ingredients
into the Spiralizer by hand or with other
utensils. Failure to use the Food Pusher
may cause personal injury.
46 If Blade Discs appear to be damaged or
broken, do not use or attempt to repair.
Call customer service for assistance.
47 DO NOT attempt to sharpen Blade Discs.
48 DO NOT remove Feed Chute Lid until
Blade Disc stops spinning.
n i n j a k i tc h e n . c o m
6