Electrolux LLI9VF54X0 Manuel De L'utilisateur page 14

Masquer les pouces Voir aussi pour LLI9VF54X0:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 226
3. Continue dispensing water for about
four minutes to flush the system 
and plumbing connections of any
impurities (stopping to empty the
glass as necessary).
Dispenser
NOTE
The water dispenser has a built-in
device that shuts off the water 
flow after three minutes of 
continuous use. To reset this
shutoff device, simply release the 
dispenser paddle.
NOTE
After the initial 750 ml, water will
remain room temperature until the
tank has refilled and been given 
enough time to chill the next
750 ml of water. May take up to
8 hours to chill.
7.3 Ice maker operation & care
After the refrigerator is installed properly
and has cooled for several hours, the ice
maker can produce ice within 24 hours.
The ice maker will fill the ice bin from the 
rear. Dispense some ice to force the ice
forward in the bin. This will allow the bin
to fill completely.
7.4 Ice Maker and Storage Bin
Capacity
This ice maker should produce 1 Kilogram
of ice per 24 hours. The ice bin will hold
about 1,6 Kilogram of ice.
7.5 Turning the fresh food
ice maker on and off
IMPORTANT
The ice maker is turned on at the
factory so it can work as soon as
the refrigerator is installed. If it is
not possible to connect a water
supply, set the ice maker's On/Off 
feature to Off; otherwise, the ice 
maker's fill valve may make a loud 
chattering noise when it attempts
to operate without water.
Ice production is controlled by the ice
maker's On/Off feature on the control 
panel. Pressing the On/Off feature turns 
the ice maker on & off.
NOTE
The ice maker also has a built-in
plastic signal arm that
automatically stops ice production
when the ice bin is full. This signal
arm should not be used
to manually stop the ice maker.
IMPORTANT
Turning off the ice maker simply 
disables ice making. Existing ice
can still be dispensed, and water
can be dispensed.
IMPORTANT
On occasion, unusually small
ice cubes may be noticed in the
bucket or in dispensed ice. This
could occur in normal operation
of the ice maker. If happening
frequently, it may be an indication
of low water pressure or the water
filter needs to be replaced. As the 
water filter nears the end of its 
useful life and becomes clogged
with particles, less water is
delivered to the ice maker during
each cycle. Remember, if it's been
six months or longer since last
changing the water filter, replace 
it with a new one. Poor quality 
household water may require
the filter to be changed more 
frequently.
CAUTION
If the water supply to the
refrigerator is softened,
be sure the softener is properly
maintained. Chemicals from
EN
13

Publicité

Table des Matières
loading

Table des Matières