Bosch GCM 216 Professional Notice Originale page 13

Mitre saw
Laser class
Divergence of laser line
Weight according to EPTA-Procedure 01:2014
Protection class
Dimensions of suitable saw blades
Saw blade diameter
Base blade thickness
Max. cutting width
Hole diameter
Permitted workpiece dimensions (maximum/minimum):
(see "Permissible workpiece dimensions", page 16)
The specifications apply to a rated voltage [U] of 230 V. These spe-
cifications may vary at different voltages and in country-specific mod-
els.
The appliance meets IEC 61000-3-11 requirements and is subject to conditional connection. The appliance can lead to occa-
sional voltage fluctuations under unfavorable power conditions. The impedance of this appliance is set as Z
user must make sure, that the connection point, with the impedance Z
impedance requirement: Z ≥ Z
actual
thority.
Assembly
Avoid starting the power tool unintentionally. The
u
mains plug must not be connected to the power supply
during assembly or when carrying out any kind of
work on the power tool.
Items included
See the list of items included at the start of the
operating manual.
Check to ensure that all the parts listed below have been
supplied before using the power tool for the first time:
– Mitre saw with mounted saw blade
– Screw clamp (22)
– Hex key (32)
– Extension bar (21) with securing screw (38) (2 x)
– Length gauge (10)
– Dust bag (1)
Note: Check the power tool for possible damage.
Before continuing to use the power tool, carefully check that
all protective devices or slightly damaged parts are working
perfectly and according to specifications. Check that the
moving parts are working perfectly and without jamming;
check whether any parts are damaged. All parts must be fit-
ted correctly and all the conditions necessary to ensure
smooth operation must be met.
If the protective devices or any parts become damaged, you
must have them properly repaired or replaced by an author-
ised service centre.
Bosch Power Tools
mrad (full angle)
kg
mm
mm
mm
mm
. If Z is unknown, determine Z
max max
Fitting individual components
– Carefully remove all parts included in the delivery from
– Remove all packing material from the power tool and the
Fitting the extension bar (see figure A)
The free end of long and heavy workpieces must have some-
thing placed underneath it or be supported.
To extend the saw table further, extension bars can be
mounted both to the left or right of the power tool.
– Unscrew the securing screw (38) from the extension bar
– Tilt the power tool.
– Push the extension bars (21) on both sides of the power
– For the pull-out safety device, screw the securing
Stationary or flexible mounting
u
Mounting on a work surface (see figure B1−B2)
– Use suitable screw fasteners to secure the power tool to
or
– Firmly clamp the base of the power tool to the work sur-
GCM 216
2
1.0
9.1
/ II
216
1.4−1.8
3.3
30
, on which the appliance shall be plugged in meets the
max
in consultation with the network supplier or supply au-
max
their packaging.
accessories provided.
with a cross-headed screwdriver.
tool all the way into the corresponding drill holes .
screw (38) back into the extension bar.
To ensure safe handling, the power tool must be
mounted on a flat, stable work surface (e.g. work
bench) before use.
the work surface. The holes (19) are used for this pur-
pose.
face with commercially available screw clamps.
1 609 92A 72S | (19.11.2021)
English | 13
GCM 216
2
1.0
9.1
/ II
216
1.4−1.8
3.3
25.4
= 0.35 Ω. The
actual