Bushnell Tour X 201540 Mode D'emploi page 13

TROUBLE SHOOTING TABLE
If unit does not turn on / display does not illuminate :
• Depress power button.
• Check and if necessary, replace battery. If unit does not respond to key presses, replace the battery with a good
quality CR2 3-volt Lithium battery.
• Ensure the display is on the brightest setting while in sunlight. While pressing Power Button, cover the objective
lenses to determine if the display is on. See the display brightness setting instructions (pg. 9).
If unit powers down (display goes blank when attempting to power the laser) :
• The battery is either weak or low quality. Replace the battery with a good quality CR2 3-volt Lithium battery.
If target range cannot be obtained :
• Make sure display is illuminated.
• Make sure that the power button is being depressed.
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the target)
that emit and receive the laser pulses.
• Make sure unit is held steady while depressing power button.
Note: The last range reading does not need to be cleared before ranging another target. Simply aim at the new target using the reticle, depress the power button
and hold until new range reading is displayed. Specifications, instructions, and the operation of these products are subject to change without notice.
Patent #'s: 6,445,444 | 5,612,779 | 6,057,910 | 6,226,077 | 5,652,651 | 7,920,080 | 7,619,548 | 7,239,377 (201441 only) |
7,859,650 (201441 only) | 7,535,553 (201441 only)
13